[ICOM] Fw: IC 775DSP to IC 2KL

[Adam Farson]

Hi Arnaldo,

You will need an OPC-118 or equivalent adapter cable (female 24-pin Molex to
male ACC1 & ACC2). If you wish to make up your own cable, the connections
are as follows. The IC-775DSP ACC(2) plug is a male 7-pin DIN, and the
accessory plug for the 2KL is a 24-pin Molex (male if plugged into the
IC-2KL, female if plugged into the IC-2KL control cable.)

ACC (2) Pin 1 (8V Band Ref.) to Molex Pin 12

ACC (2) Pin 2 (GND) to Molex Pin 8

ACC (2) Pin 3 (SEND) to Molex Pin 3

ACC (2) Pin 4 (0 ~ 8V BAND) to Molex Pin 13

ACC (2) Pin 5 (ALC) to Molex Pin 7 (Mandatory!)

ACC (2) Pin 6 (TRV) NC

ACC (2) Pin 7 (13.8V) NC

The IC-2KL and AT-500 user manuals and other documents are downloadable
here:

http://www.qsl.net/icom/manuals.html

The AT-500 autotuner is an ideal companion to the 2KL. 

During the ALC adjustment procedure, the IC-775DSP output should not exceed
100W. Set the RF power control of the IC-775DSP just at the point where the
IC-2KL output levels at 500W, with the ALC correctly adjusted. The IC-2KL
power gain is approx. 10 dB, so 50W should drive the 2Kl to 500W output. The
775's ATU should be disengaged.
 
Cheers for now, 73,
Adam VA7OJ/AB4OJ

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Arnaldo
Sent: 06 February 2007 07:52
To: ICOM Reflector
Subject: [ICOM] Fw: IC 775DSP to IC 2KL


 Hi All,
 
 Could someone help with the wiring between the IC 775 DSP and the IC 2KL.
 
 Thanks in advance
 
 Arnaldo
ZS5ADS



Scanned for viruses by Blue Coat
http://www.WinProxy.com/