[-] Re: [ICOM] IC-775DSP

[Juan Pablo Mercé LU4DX]

Hi Paul

Good question! Even I did not test with dummy load, I am going to try to
obtain one and it will try that it happens.

Tnx, Paul LU4DX


----- Original Message ----- 
From: "Paul Playford" <paul at w8aef.com>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Monday, April 09, 2007 1:41 PM
Subject: Re: [-] Re: [ICOM] IC-775DSP


> Good Morning Paul
>
> I have been following your comments about the 775 and it is nice to know
you
> are enjoying it.
>
> How does the 775 perform into a dummy load on 15m?
>
> de Paul, W8AEF
>
> ZF2JL/ZF2TA  FO8DX/FO8PLA  8Q7AA  XZ0A  VU7RG
>
> ----- Original Message ----- 
> From: "Juan Pablo Mercé LU4DX" <lu4dx at hotmail.com>
> To: "ICOM Reflector" <icom at mailman.qth.net>
> Sent: Monday, April 09, 2007 14:00
> Subject: [-] Re: [ICOM] IC-775DSP
>
>
> > Hi Paul, a pleasure of seeing it for here again.
> > Your ex-775DSP work fabulously!!, I add INRAD's roofing filter and SSB
> > narrow filters.
> > I make him a question because you know very well my IC-775DSP because it
> > was
> > yours !!
> > Often and only in 15 meters when I apply power to my antenna that very
low
> > ROE has, the rig shoots all the power in a few seconds and then it
lowers
> > the power as if ROE existed to approximately 90 watts.
> > I connect the tuner, it fits 1:1 and begins to extract all the power
> > again,
> > then I disconnect the tuner and the power returns to the normal one
> > without
> > diminishing. I think that it is not a problem of ROE but of the form
that
> > stays any bobbin in the tuner that as soon as everything gets
accommodated
> > is corrected.
> > Do I spend this to him at some time?
> >
> > 73 Paul LU4DX
> >
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>