[ICOM] IC-215 alignment inst. ???
Clif Holland
avvidclif at wildblue.net
Tue Oct 24 13:50:38 EDT 2006
All my file srawer shows is an operating manual with schematic. It's a
pretty safe bet there isn't a service manual.
Clif Holland KA5IPF
www.avvid.com
----- Original Message -----
From: "Dave Edwards" <kd2e at comcast.net>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Tuesday, October 24, 2006 12:36 PM
Subject: Re: [ICOM] IC-215 alignment inst. ???
> Mac.....I do have the owner's manual. It has a simplified theory of op,
> and a block diagram and schematic. I suppose I could just tune the RF
> stage on xmit, and go through the IF stages on receive...but when
> alignment instructions exist, I like to follow them. I suppose I'll check
> the receive with a generator, and the xmit on a wattmeter to see just how
> off it is from 145 to 146 range. Might not be worth it, especially if
> those little xfmr cans are full of wax!
> ...Dave
> ----- Original Message -----
> From: "D C *Mac* Macdonald" <k2gkk at hotmail.com>
> To: <icom at mailman.qth.net>
> Sent: Tuesday, October 24, 2006 12:19 PM
> Subject: RE: [ICOM] IC-215 alignment inst. ???
>
>
>> Do you have the owner manual? I doubt
>> that there is any service manual for it.
>> Icom owner manuals had theory of operation
>> back in the days before no-code/know-nothing
>> licensing. That should give you an idea as to
>> where to start. Owner manual came with a
>> full schematic.
>>
>> Mac - K2GKK/5
>>
>>
>>
>> ----Original Message Follows----
>> From: "Dave Edwards" <kd2e at comcast.net>
>> Reply-To: ICOM Reflector <icom at mailman.qth.net>
>> To: <icom at mailman.qth.net>
>> Subject: [ICOM] IC-215 alignment inst. ???
>> Date: Tue, 24 Oct 2006 11:59:46 -0400
>>
>> I have an old IC-215 2M crystal rig.
>> It works 100%, but it is a European version (145 Mhz range).
>> With rocks for 146.52 in it, the output is a bit down from all the other
>> 145 range crystals.
>>
>> I'd like to peak it for the 146 range.
>> Does anyone know where I can find alignment instructions, or a service
>> manual for this 'ol rig?
>>
>> Thanks for any tips!
>> ...Dave
>>
>>
>> ----
>> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>
More information about the Icom
mailing list