[ICOM] Correction - ATU Mobile

[Edward L. Dowdy]

The Paducah Dummy Load! Built by NU4W. It was cheap. Actually it's not a bad
antenna. But it's not a predator (N9JMX). It would be a lot more fun if I
had another MKIIG. It looks lonely sitting in the garage...

73,
Ed KA9EES

----- Original Message ----- 
From: "Jerry Keller" <k3bz at arrl.net>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Friday, March 10, 2006 8:15 PM
Subject: Re: [ICOM] Correction - ATU Mobile


> Which one do you have, Ed?
>
> 73,  Jerry K3BZ
>
> ----- Original Message ----- 
> From: "Edward L. Dowdy" <ka9ees1954 at insightbb.com>
> To: "ICOM Reflector" <icom at mailman.qth.net>
> Sent: Friday, March 10, 2006 7:55 PM
> Subject: Re: [ICOM] Correction - ATU Mobile
>
>
> > The screwdriver I have is a center loaded antenna.
> >
> > 73,
> > Ed KA9EES
> >
> > ----- Original Message ----- 
> > From: "Michael P. Olbrisch" <mike2004 at elp.rr.com>
> > To: "'ICOM Reflector'" <icom at mailman.qth.net>
> > Sent: Friday, March 10, 2006 5:20 PM
> > Subject: RE: [ICOM] Correction - ATU Mobile
> >
> >
> >>
> >>
> >> > -----Original Message-----
> >> > From: icom-bounces at mailman.qth.net
> >> > [mailto:icom-bounces at mailman.qth.net] On Behalf Of William Lambing
> >> > Sent: Friday, March 10, 2006 6:17 PM
> >> > To: ICOM Reflector
> >> > Subject: Re: [ICOM] Correction - ATU Mobile
> >> >
> >> > A screwdriver will work better than hustlers and do not
> >> > require you to get out of the car.
> >>
> >> I disagree.  Run it and see.  It is quite simple - a center loaded
> >> antenna
> >> (Hustler) will out perform a base-loaded antenna (Screwdriver).  You
can
> >> play with the efficiency of the coils a bit, but the results aren't
worth
> >> talking about.
> >
> >
> > ----
> > Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> > Icom Users Net: Sundays, 1700Z, 14.316 MHz
> > Icom FAQ: http://www.qsl.net/icom/
> >
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/