[ICOM] 775 will not xmit

[John Germanos]

Vladimir,

Installation not very dificult. I have two 775DSP radios. I installed my 
first Inrad roofing filter in one of them already. What a noticable 
difference. I now have received my second filter.

You will need a long phillips screwdriver in order to take out the PA 
section, not completely remove might needs be lifted slightly. Also, there 
is an additional screw on the RF front end board that you need to remove 
that is not in the directions, it is loced on the back of the radio next to 
the receive antenna input.
Be carefull when moving the power supply, a long plastic shaft comes out of 
the power supply and inserts into the power switch on the front of radio. 
Other than those suggestions, the directions are very good.

Hope this helps,

John WB9PNU



----- Original Message ----- 
From: "Vladimir V. Sidorov" <ve3iae at rac.ca>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Tuesday, January 31, 2006 12:38 PM
Subject: Re: [ICOM] 775 will not xmit


> Art,
> Did you find the installation of the filter complicated and time consuming 
> or not? I have found my roofing filter in my mailbox today and simply 
> would like to make some time planning for the installation.
>
> Thanks and
> 73,
>
> Vladimir VE3IAE
>
>
> --- 
>
>
>
> With the help of George @INRAD I seated J-2in the PA unit.
> This cable came out when the PA was moved.  I can listen thru the BC QRM 
> on 40 now, just need a contest.
> Art Sellers W3TZ
> ----
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.375 / Virus Database: 267.14.25/246 - Release Date: 1/30/2006
>
>