[ICOM] IC2KL Bias supply

[W. David Paperman]

Larry;

thank you for your response.

Other than the IC2KL I use the other amps have the defective bias supply.

Reinstalling a repaired supply, I could cut the leads and measure the 
load current as you suggest. This would probably be the most accurate 
way of obtaining the the values of the average load current  ---
however ---, I thought someone might have been through this before, such 
as Gary Fiber, or might know where that information may be "hidden".

Dave, W5WP


Lawrence Young wrote:

> Dave: Why not use one of the amps you have on hand and measure the current under full load, then 

substitute an equvalent load in your test fixture? Larry K4LXV
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> 
> .
>