[ICOM] IC746 Reduced Output

[Clif Holland]

Don't measure the voltage at the power supply. Measure it inside the radio 
after it goes thru the power connector...Also it should be 13.9-14 in rx and 
tx.

Clif Holland KA5IPF
www.avvid.com


----- Original Message ----- 
From: "Mike" <k4gmh at arrl.net>
To: <icom at mailman.qth.net>
Sent: Sunday, February 26, 2006 9:32 PM
Subject: [ICOM] IC746 Reduced Output


> Hello,
>
> Recently I've noticed the output on my Icom 746 is around 70 W.  The 
> reduction has been slowly going down, ~3 mo. as best that I can remember. 
> The output is the same for CW or SSB , with a single tone.
>
> The power supply is still putting out 13.19 volts to the radio under full 
> load, 13.48 under no load.
>
> Any ideas on what can be done to get the radio back up to full output?
>
>         73,
>         Mike, K4GMH
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>