[ICOM] 756 Pro No power out

[jim fox]

Yes, The power out readings were taken with the amp disconnected (control 
line) Short coax from ant 1 to bird and 4 ft coax to dummy load.. Amp is the 
IC 4-KL so nothing attached to the ALC or Send jacks on back of the 756 
Pro..  Thanks,   Jim


>From: "Lawrence Young" <younlr at mybluelight.com>
>Reply-To: ICOM Reflector <icom at mailman.qth.net>
>To: icom at mailman.qth.net
>Subject: Re: [ICOM] 756 Pro No power out
>Date: Fri, 10 Feb 2006 02:44:30 GMT
>
>Jim: did you try the rig alone into a dummy load with no ALC connection to 
>the amplifier just in case the power was being reduced by a fault in the 
>ALC voltage being input from the amplifier? Good luck, Larry K4LXV
>----
>Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>Icom Users Net: Sundays, 1700Z, 14.316 MHz
>Icom FAQ: http://www.qsl.net/icom/