[ICOM] AH-2 Controler

[Edward Dickinson, III]

The AH-2 Control Head came with the AH-2 ATU.  It was for the 735 which did
not have the 'Tune' function built into it.  I don't think the control head
was ever offered separate from the AH-2 ATU.  When the rigs began to have
the Tune function built into them, the control head was dropped and the AH-2
became the AH-3.  As far as to whether or not it will work with the
AH-4/735, some on this reflector might be able to offer an educated guess.
My uneducated guess would be yes.

Regards,
Dick - KA5KKT/4  

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Ynkedragon at aol.com
Sent: Sunday, August 06, 2006 7:07 PM
To: icom at mailman.qth.net
Subject: Re: [ICOM] AH-2 Controler


In a message dated 8/4/2006 23:50:56, softblue at alltel.net writes:

<< The '735' controler for the AH-2 also works for sure with the IC-730,
740,
745 and 751A.  In the case of the non-735 units the extra cable to throtle
back the power as is used on the 735 is not needed.  However a 24 pin molex
to DIN plug is needed with those other rigs.  >>

I'm curious about this "735 controller".  What is it:  an ICOM product, an
aftermarket product or a homebrew item?  Will it allow use of the AH-4 with
a '735?

73, Blair k3yd


----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/