Fw: [ICOM] Help with 751 needed

[D & M Pendergast]

G'day Marty,

The IC-751 does have an internal fuse on the 'inside' end of the DC input.
A little unclear on the schematic as to which line it is in but the
schematic rates it as 3 A.

However, the internal view in my operating manual shows two inline fuse
holders pictured.

A bit difficult to determine what else may have fused in the circuitry by
looking at the schematic but you might be lucky and have restricted the
damage to only the fuse!

Hope this helps.

Regards,

Des - VK3DMP.


----- Original Message ----- 
From: "Marty" <kt4k at bellsouth.net>
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Sent: Friday, September 23, 2005 3:58 AM
Subject: [ICOM] Help with 751 needed


> Anyone have the cure for this problem? While powered up, I shorted out the
wires
> to the meter bulb (I know, I'm still kicking myself) now the rig is dead.
> External fuses OK. Is there an internal fuse to look for or anyone have
this
> happen that can help? Any help appreciated.
> IC751 DC (not A).
>
> Marty KT4K
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>