[ICOM] IC775DSP problems

[Augie Hansen]

On 3/9/05 1:26 PM, "Michael Sell" <k0com at comcast.net> wrote:

> 1.  Rig control no longer works with any software (writelog and dx4win) -
> not an address issue.  While I do see digital output at the rear panel jack,
> it looks funny.  Any one experience component failure in the rig control
> circuit?   Perhaps do to RF getting into the radio, etc?

Check the transmission rate. Perhaps you set it to a different value for
some other program?
 
> 2. CW and RTTY output is dependent on where the drive control for the speech
> processor is set??!!??  I never use the speech processor so I had turned the
> control all the way down.  This caused no output on CW and RTTY.  I have to
> turn the drive control up to at least 12 o'clock to get full output on CW
> and RTTY.  Took me two years to figure this out on my own.  Two trips to
> Icom resulted in no problem found both times.   Is this normal?

This is as it should be.

73, H
Gus Hansen / KB0YH