[ICOM] AMP INTERFACE TO 756 PRO II

[Jim Miller]

I would rather replace an inexpensive relay than be without my radio and
have to tear it apart or send it in for repair because I thought it was
meant to "handle" the load.  I am NOT willing to risk my radio for the cost
of an external relay if anything "happens" out of the norm.

Just my 2 cents,
73, de Jim KG0KP

----- Original Message ----- 
From: "MikeR" <nf4l at nf4l.com>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Tuesday, June 14, 2005 5:38 PM
Subject: Re: [ICOM] AMP INTERFACE TO 756 PRO II


> Dan -
> My PRO II manual says the relay can handle 16V @ 2 amps. I saw a lot of
stuff on the web
> indicating that was a misprint, and the specs were much lower.  Take a
look here:
> http://www.qsl.net/icom/auxrelay.html
> There is apparently a lot of confusion about the relay in the PRO line. I
use a buffer.
> It's cheap insurance.
> 73, Mike NF4L
>
> Dan Coleman W8KMX wrote:
> > I want to interface an Ameritron ALS-600 to an ICOM 756 Pro II.  Has
> > anyone done this and is there any special hookup that is needed?
> > Dan
> > ----
> > Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> > Icom Users Net: Sundays, 1700Z, 14.316 MHz
> > Icom FAQ: http://www.qsl.net/icom/
> >
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>