[ICOM] AMP INTERFACE TO 756 PRO II

[Malcolm Ringel]

Dan: I use this combination and have for a while  ... works just fine. I do 
not have any outboard relay and believe that none is needed. Look in the 
PROII manual. I think they describe it (the hook-up)in "non-Icom amplifier 
use" or some such heading.  I have not generally used the ALC line , but , 
for some reason, after moving QTH and re-assembly, I did. The plugs are on 
the rear panel and are labeled. Again, see the book.
The amp is a good one and will protect itself from most typical errors. 
Don't over-drive it ... the risk-reward ration there is not in your favor.
Malcolm, K3KZ
----- Original Message ----- 
From: "Dan Coleman W8KMX" <w8kmx at bellsouth.net>
To: <icom at mailman.qth.net>
Sent: Tuesday, June 14, 2005 4:17 PM
Subject: [ICOM] AMP INTERFACE TO 756 PRO II


>I want to interface an Ameritron ALS-600 to an ICOM 756 Pro II.  Has anyone 
>done this and is there any special hookup that is needed?
> Dan
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>