[ICOM] IC-745 & IC-EX242 FM board

[Reid Bishop]

Mike,

I don't think this is an issue with the speech compressor switch.  I have
noticed no issues with this switch to date, and it is functioning fine when
the FM module is not plugged in.  What are the classic symptoms of a bad
speech compressor switch?

Thanks for your input!

Reid - KC0TAR

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Michael P. Olbrisch
Sent: Tuesday, January 11, 2005 6:46 PM
To: 'ICOM Reflector'
Subject: RE: [ICOM] IC-745 & IC-EX242 FM board



Although the problem seems to stem from the FM module, dig a bit deeper.
Other than the installing and removing of the FM board, your symptoms
describe exactly what is the number 1 problem of the 740 series.  That is a
bad speech compressor switch.  When I sold my 740 I installed a new switch
and sent along a spare - just in case.

If it is your switch, make every effort to just replace it.  Cleaning it at
best is an iffy proposition - it just doesn't work.

GL.


Mike.  KD9KC

My E-mail address: mike2004 at elp dot rr dot com
Ham Radio page: http://www.qsl.net/kd9kc/
Gun page: http://home.elp.rr.com/elpasochl/
Dog page: http://www.geocities.com/heartland/estates/4174

Member:
National Rifle Association.
Franklin Mountain Gun Club.
Texas State Rifle Association.
Fort Bliss Practical Shooting Club.
United States Practical Shooting Association.

Holder:
Texas Concealed Handgun License.

U.S. Army Retired.

Freedom is expensive.  Those who are not willing to
pay the price ultimately lose everything.



> -----Original Message-----
> From: icom-bounces at mailman.qth.net 
> [mailto:icom-bounces at mailman.qth.net]On Behalf Of Reid Bishop
> Sent: Wednesday, January 12, 2005 1:19 AM
> To: 'ICOM Reflector'
> Subject: [ICOM] IC-745 & IC-EX242 FM board
>
>
>
> Hi,
>
> I recently plugged a never-used IC-EX242 FM board into my IC-745.  
> Seems to work great, but I did end up with one issue.  When this board
> is plugged in,
> the 745 refused to output any power whatsoever in SSB, RTTY,
> or CW mode.
> All the relays click, the TX lamp lights up, but absolutely
> zero output.  TX
> on FM works fine.
>
> Once I pulled the IC-EX242 board out, then SSB, CW, and RTTY modes 
> worked fine again.  I plugged the EX242 back in, carefully following 
> the instructions just to be sure, and it still had the same problem.
>
> Any thoughts?


----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net Win a new
Icom IC-756 PRO III and help QSL/QTH.net Details at: http://mailman.qth.net/