[ICOM] Computer Control Interface

[Gary Fiber]

Bob,

I was looking at the MFJ-1279 schematic and the CW out is using a 
Opto Isolator. In the past I remember an Opto isolator not being able 
to place a hard enough ground on the Icom UP / Down input.
The AEA DSP-2232 users had to install a transistor to provide hard 
enough ground so the DSP-2232 would cause a frequency change, mostly 
to the IC-970. This was done for Doppler shift frequency tracking.
I looked at the Buxcomm site but he has some much stuff it would take 
a week to find the product you are using listed.

Gary K8IZ

At 07:58 AM 12/27/2005, you wrote:
>Ok I give up on this little project, it is quickly
>becoming not worth my time.
>
>Is someone using an interface with an Icom PRO or II or
>III that does all the soundcard modes and FSK modes along
>with keying CW from A SINGLE COMM PORT that actually
>works?
>
>I would like to know what your using so I can look into
>getting one.
>
>What is recommended by you guys with the experience?
>
>
>
>   73 fer nw,
>Bob AD5VJ