[ICOM] IC-910H Problem

[w1gud at tampabay.rr.com]

Mike...it might be your AFC...if the repeater(s) you are monitoring are 
off frequency, the busy lights will blink. turn on the afc control, and 
the vfo will lock onto the proper frequency. we have a uhf repeater 
here in tampa that was slightly off frequency, and i used the afc to 
lock it in (busy lite stopped blinking) and i stored the ACTUAL 
frequency into memory. eventually they put the repeater on 
frequency...and i put my vfo on the correct frequency, again saving it 
to memory, and no more blinking.
I hope its that simple. I love my 910H ... but its very short on 
metering...something i wish wasn't so
73, Warren W1GUD
Tampa, Florida

----- Original Message -----
From: "Michael P. Olbrisch" <mike2004 at elp.rr.com>
Date: Sunday, August 28, 2005 10:54 am
Subject: RE: [ICOM] IC-910H Problem

> 
> I don't own a 910.  But I did sleep at a Holiday Inn last night.
> 
> I would bet on something in the PLL.  My 820 did this, and it was 
> a bad cap
> in the PL causing it.
> 
> Good luck.
> 
> Mike. KD9KC
> El Paso, TX. 
> 
> > -----Original Message-----
> > From: icom-bounces at mailman.qth.net 
> > [mailto:icom-bounces at mailman.qth.net] On Behalf Of Ron Tivey
> > Sent: Sunday, August 28, 2005 2:08 PM
> > To: ICOM
> > Subject: [ICOM] IC-910H Problem
> > 
> > Hello All,
> > 
> >     I have a IC-910H and a minute or two after it is turned 
> > on the Main 
> > and Sub band indicators start to blink.  I've seen this 
> > before but can't 
> > remember what it means.  Anyone out there know?
> 
> 
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>