[ICOM] Power cord

[Adam Farson]

Hi Chris,

You can draw +13.8V power for the tuner from ACC(1) or ACC(2) Pin 7
(+13.8V), with Pin 2 as ground (-). The maximum current load is 1A. I would
recommend that you place a 250mA or 0.5A fast-blow fuse in series with the
tuner power lead, depending on the current consumption.

Cheers for now, 73,
Adam VA7OJ/AB4OJ


-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Chris BONDE
Sent: 09 April 2005 17:39
To: ICOM Reflector
Subject: RE: [ICOM] Power cord

Thank you Adam.
So any 6-pin Moles will work?  I tried one but there was some slack.  Will
order one.

I have an AMERITRON ATR-15 that requires a wall wort to run the meter and
the other things.  If I turn on my station and just use the 2M then I have
the HF ant tuner on.  I was just wondering if I could hook it up so that the
tuner would only turn on when I turn the IC 750 PRO (old) on.  SO I was
thinking of taking the power from the ACC! or 2 socket.

I have just obtained a ICOM power supply that turns on only when the rig is
turned on.  But I suspect that it is running something all the time.

I have a master switch that turns on the ham shack equipment.  It is a
computer surge etc.  One master switch with 5 sub switches.  Turn the master
on then turn on the HF or the VHF via the sub switches.  The surge protector
is built in, also when the main switch is off I have some surge protection.

Again thank you Adam.
Chris opr VE7HCB 


Scanned by WinProxy
http://www.Ositis.com/