[ICOM] pw-1 question

awallacejr at sbcglobal.net awallacejr at sbcglobal.net
Sat Sep 18 17:23:41 EDT 2004


Push the 781 tune button?

Andy K5VM

----- Original Message ----- 
From: "Steve N4LQ" <n4lq at iglou.com>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Saturday, September 18, 2004 4:14 PM
Subject: Re: [ICOM] pw-1 question


> Thanks for the reply
> I'm using an IC-781. I also have the PRO2 and haven't hooked it to the 
> pw-1
> yet. Maybe it will act differently. When I hit the tuner button on the 
> pw-1,
> nothing happens until I go to cw mode on the 781 and apply some power by
> holding down the key.
> Steve N4LQ
> ----- Original Message ----- 
> From: "William Diamond" <wjdiamond at sbcglobal.net>
> To: "ICOM Reflector" <icom at mailman.qth.net>
> Sent: Saturday, September 18, 2004 4:48 PM
> Subject: RE: [ICOM] pw-1 question
>
>
>> Don't now what kind of exciter you are using but on my PW1 and PRO II, I
>> just push the tune button and the rig applies a small amount of RF and 
>> the
>> tuner in the amp tunes just fine..
>>
>>
>>
>>
>>
>>
>>            WILLIAM J. DIAMOND
>>           ROGERS, ARKANSAS USA
>>
>>         HAM RADIO OPERATOR WRØT
>>  VISIT MY NEW RADIO ROOM REVISED 7-04, AT
>>            www.wjdiamond.com
>>
>>        DIGITAL PHOTOGRAPHY SITE IS AT
>> http://pages.sbcglobal.net/wjdiamond/index.html
>>
>>
>> -----Original Message-----
>> From: icom-bounces at mailman.qth.net
>> [mailto:icom-bounces at mailman.qth.net]On Behalf Of Steve N4LQ
>> Sent: Saturday, September 18, 2004 2:30 PM
>> To: ICOM Reflector
>> Subject: [ICOM] pw-1 question
>>
>>
>> Just got a pw-1 and love it but I have one question. The manual is very
>> vague about how to properly activate and tune the auto tuner. It says to
>> push the tuner button for 2 seconds and the tuner will  start
> automatically.
>> Well this isn't quiet the whole story. It needs a little RF to get going!
> Is
>> the manual that defficent or am I missing something? I've been switching
> to
>> cw mode, pushing the tuner button for 2 seconds and keying the rig until
> the
>> swr dips to 1. Any suggestions?
>> Steve N4LQ
>> ----
>> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>>
>>
>> ----
>> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/ 




More information about the Icom mailing list