[ICOM] Inrad 109 instead of Murata K5

[Adam Farson]

Hi Anders,

This should not be too difficult, as the PC tracks and mounting holes for an
Icom FL-44A (or equivalent) are already present on the IF board.

As the clearance between the solder side of the board and the diecast
chassis is less than 3 mm, you will need to cut the filter pins off nearly
flush with the board. 

Cheers for now, 73,
Adam VA7OJ/AB4OJ


-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Anders Janis
Sent: 25 November 2004 07:11
To: icom at mailman.qth.net
Subject: [ICOM] Inrad 109 instead of Murata K5

I am about to exchange the  Murata SSB filter in my IC-746 to a inrad 109.
Any thoughts or advices?

/Anders SM4RNA


Scanned by WinProxy
http://www.Ositis.com/