[ICOM] 25A

[Ken, WA2LBI]

Loren,

I haven't seen any further responses so I don't know if you resolved your
problem. Ted is probably correct about the Priority mode. I had one of these
rigs years ago and IIRC it was easy to bump the Priority button. I'm sure you
checked that. If you use it for packet, as I did, you only use one frequency.
If the rig is put in Priority it won't switch back and forth checking another
freq  because there is only one and it will act as you describe. As for a reset
sequence, I don't believe this rig had one. About all you can do is remove the
power.

Good luck and let us know what you find.

Ken, WA2LBI
wa2lbi at arrl.net

Quoting Ted Wright <wrighttk at erols.com>:

> Hello
> I believe you have locked it on that frequency via the priority function
> If you have a function key press that and hold for few seconds then
> press the other key that doubles as the priority key . If you have those
> keys on the rig , I am not too familiar with that Icom . If all else
> fails try a reset ..
>
> Loren James wrote:
>
> > THIS IN AN OLD RIG I USE  FOR PACKET AND WHEN I TURNED IT ON I SEE
> > THAT IT WILL NOT CHANGE FREQ AT ALL. THE PRIORITY LIGHT IS LIT AND I
> > HAVE NOT SEEN THIS BEFORE. IT SEEMS TO TX BUT CANNOT CHANGE FREQUENCY.
> > ANY IDEAS? THAN YOU FOR ANY AND ALL HELP. N2LSJ
> >
> > ----
> > Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> > Icom Users Net: Sundays, 1700Z, 14.316 MHz
> > Icom FAQ: http://www.qsl.net/icom/
> >
> >
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>