[ICOM] PW 1

[William Diamond]

Hi Johnny and the group.

Did you make your own accy connect cable or did you get it from Icom???

Does anyone know if the cable has to be shielded??

Thanks

      William J. Diamond
       Rogers, Arkansas

    Ham Radio Operator WR0T

   Please Visit My Radio Site
        wjdiamond.com



-----Original Message-----
From: icom-bounces at mailman.qth.net
[mailto:icom-bounces at mailman.qth.net]On Behalf Of js
Sent: Saturday, June 26, 2004 8:41 AM
To: ICOM Reflector
Subject: Re: [ICOM] PW 1


Hi William,

I am now running my pro2 and K2/100 with PW1.  I do not realise any problem
of RF nor any requirement of specific coax cable length.

I do not see any problem in my case.  So far so good.

73

Johnny Siu  VR2XMC
----- Original Message -----
From: "William Diamond" <wjdiamond at sbcglobal.net>
To: "Icom at Mailman. Qth. Net" <icom at mailman.qth.net>
Sent: Saturday, June 26, 2004 12:12 PM
Subject: [ICOM] PW 1


> Hi all you PW 1 owners out there, I have a couple of questions.
>
> I am thinking of adding a 2nd Icom rig to the PW1 and is the coax cable
> supposed to a specific length like the old Collins amps required?
>
> Is anyone running 2 rigs on one?  I am a bit concerned about that much RF
> being in the same box with a second rig?
>
> I remember what happened to my 2nd PRO II from a MFJ coax switch. I was
> running one of them and it was selected by the coax switch and the front
end
> of the other one got wiped by the close spacing of the switch contacts and
I
> was just running 100 W.
>
>       William J. Diamond
>        Rogers, Arkansas
>
>     Ham Radio Operator WR0T
>
>    Please Visit My Radio Site
>         wjdiamond.com
>
>
>
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/