[ICOM] 765 output

[William Diamond]

Been there on that one.....  As I recall there are 4 diodes that should be
replaced to prevent it again.



           WILLIAM J. DIAMOND
          ROGERS, ARKANSAS USA

        HAM RADIO OPERATOR WRØT
 VISIT MY NEW RADIO ROOM REVISED 7-04, AT
           www.wjdiamond.com

       DIGITAL PHOTOGRAPHY SITE IS AT
http://pages.sbcglobal.net/wjdiamond/index.html


-----Original Message-----
From: icom-bounces at mailman.qth.net
[mailto:icom-bounces at mailman.qth.net]On Behalf Of George, W5YR
Sent: Thursday, August 26, 2004 10:45 PM
To: ICOM Reflector
Subject: Re: [ICOM] 765 output


John, Q14 has blown. It feeds the RF output stages via miniature coax.
Replace it with a 2N2222 until Icom can send you the proper transistor for
replacement. There are a number of mods that reduce the likelihood of
blowing Q14. Icom should be able to give you the info.

73, George W5YR
Fairview, TX
w5yr at att.net
http://www.w5yr.com


----- Original Message -----
From: "NABEREZNY JOHN" <John_WE2F at msn.com>
To: <icom at mailman.qth.net>
Sent: Thursday, August 26, 2004 4:17 PM
Subject: [ICOM] 765 output


Hi Folks,
   I lost output on my 765 in all modes and all bands. I have collector
voltage, but it appears as though  no drive. Suggestions needed.
   thanks, John WE2F

----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/

----
Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/