[Icom] IC2AT

Tue, 10 Jun 2003 10:13:46 -0700

Hi Bob,

You will need to connect the output of the CTCSS encoder to the slider of
the deviation pot via a 0.47 uF ceramic capacitor, the (+) lead to the
positive power rail on the switched side of the on/off switch, and the (-)
lead to a ground point on the main board.

The location of the deviation pot is shown on p. 5 of the User Manual,
downloadable here:

http://www.qsl.net/icom/download/ic2e_a_man.pdf

Best 73,
Adam, VA7OJ/AB4OJ
North Vancouver, BC, Canada
http://www.qsl.net/ab4oj/
Icom FAQ site:
http://www.qsl.net/icom/

-----Original Message-----
From: [email protected] [mailto:[email protected]]On
Behalf Of Bob Marzari
Sent: Monday, June 09, 2003 14:54
To: Icom
Subject: [Icom] IC2AT

Hi,

Have a new young ham that needs CTCSS in his oldie but goodie radio.

I have a CTCSS encode module I would like to interface to an IC2AT.

I have been looking for a site that might have information on a good place
to inject the tones.

I have no schematic at this point.

Anyone been there?

TIA

Bob, W3PT

----
Your Moderator: Dick Flanagan W6OLD, [email protected]
Icom Users Net: Sundays, 1700Z, 14.315 MHz
Icom FAQ: http://www.qsl.net/icom/