[Icom] ICOM 756 PRO II STANDING CURRENT

Sun, 20 Jul 2003 10:25:58 -0400

Sorry you have had no replies....I am surprised, as this is a good, helpful
group...I hope someone who has access to this info will send it to you.
Good luck, 73,
Malcolm, K3KZ
----- Original Message ----- 
From: "PY5EG" <[email protected]>
To: <[email protected]>
Sent: Sunday, July 20, 2003 9:56 AM
Subject: [Icom] ICOM 756 PRO II STANDING CURRENT


> Hi Friends,
> I have just replaced the two driver transistors in the ICOM 756PROII I
> do
> not however have information as to the amount of standing current which
> must
> be adjusted by the driver bias potentiometer,the operators manual is non
> technical and does not publish this type of information.Would you kindly
> try
> to find out the value of no signal driver standing current to be set by
> the
> bias potentiometer,as there are two driver transistors the value should
> be
> for both of them.
> 73--Oms PY5EG
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>