[Icom] Ic-756ProII Problems

Sat, 11 Jan 2003 15:50:54 -0800

Hi Roland,

Unless the Icom factory service centre in Bellevue, WA is backlogged, I
would suggest sending the radio there.

"Silly" question: Did you disconnect the mic and keyer cords, and verify
that the front panel [TRANSMIT] key is not depressed? Also, is the red TX
LED lit when the radio is "stuck" in transmit mode?

Best 73,
Adam, VA7OJ/AB4OJ
North Vancouver, BC, Canada
http://www.qsl.net/ab4oj/
Icom FAQ Site:
http://www.qsl.net/icom/

-----Original Message-----
From: [email protected] [mailto:[email protected]]On
Behalf Of Roland Guidry - WA5CHX
Sent: January 11, 2003 08:30
To: [email protected]
Subject: [Icom] Ic-756ProII Problems

I was operating CW and when I quit transmitting the receiver went into
receive mode and then a few seconds later went into transmit mode. I was
operating barefoot. I disconnected all cables to PC and reset the CPU in the
radio to no avail. Doesn't this always happen on a Saturday. Does anyone
have any ideas? Otherwise less than 1 yr old Pro goes in for warranty work.
Any advice if I should send direct to ICOM in WA or use one of their service
centers in Louisiana.

Roland, WA5CHX