[Icom] Knobalogy
[email protected]
[email protected]
Mon, 17 Feb 2003 19:28:08 -0600
Hi Matt-
I'm probably being too cautious but if there is a way to get oil into the
optical encoder, I could do it--based on my past experiences with kludging
with various electronic, optical and mechanical widgets :-) If the slight
"sticky" feeling increases, I'll give it a try though.
I know, I know--"appliance operator" but, hey, I'm having fun and am over
260 DX countries with my part-time playing.
Andy K5VM
----- Original Message -----
From: "Matt Erickson" <[email protected]>
To: <[email protected]>
Sent: Monday, February 17, 2003 6:45 PM
Subject: Re: [Icom] Knobalogy
> Wow! I didn't know that "pulling the knob off, and placing a drop of oil
would be that hard", but then I guess I am a little more "simple minded"
than most.
> 73 de Matt
>
> At 06:22 PM 2/17/03 , you wrote:
> >Matt-
> >
> >Thanks for the "heads up". The knob feel, even with attempts to adjust,
on
> >both my 756 Pro and now my 756 Pro II have never been as smooth as on my
> >775DSP. Not sure I'm ready to tackle the lube job though--I'm all thumbs
> >with this sort of project.
> >
> >Andy K5VM
> >
> >----- Original Message -----
> >From: "Matt Erickson" <[email protected]>
> >To: <[email protected]>
> >Sent: Monday, February 17, 2003 5:49 PM
> >Subject: [Icom] Knobalogy
> >
> >
> > > Hi guys,
> > > I have a new page on my web site, the addresses the "sticky" knob
issue on
> >the 756 series (PRO series mainly).
> > > Stop in and look it over, as well as the home page.
> > > www.qsl.net/kk5dr/spinDr.htm
> > >
> > > www.qsl.net/kk5dr/
> > >
> > > 73 de Matt KK5DR
> > > ----
> > > Your Moderator: Dick Flanagan W6OLD, [email protected]
> > > Icom Users Net: Sundays, 1700Z, 14.315 MHz
> > > Icom FAQ: http://www.qsl.net/icom/
> >
> >----
> >Your Moderator: Dick Flanagan W6OLD, [email protected]
> >Icom Users Net: Sundays, 1700Z, 14.315 MHz
> >Icom FAQ: http://www.qsl.net/icom/
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/