[Icom] PW-1 Amp Separation Cable

[Siu Johnny]

Don is correct.  My PW-1 is with 10 pins but my colleague's older unit only
has 9 pins.

73
Johnny Siu VR2XMC

----- Original Message -----
From: "VE6JY Don Moman" <ve6jy@freenet.edmonton.ab.ca>
To: <icom@mailman.qth.net>
Sent: Wednesday, February 12, 2003 4:37 AM
Subject: Re: [Icom] PW-1 Amp Separation Cable


> Later units have the 10 pin cable (to allow the unit to power up the logic
> and therefore  pass RF thru the various switch ports etc even when the amp
> is off line) rather than the earlier 9 pins used.  The cable isn't
complex,
> just measure continuity on the one you suspect.
>
> The cable on the remote end is a little tough to get seated in properly -
in
> doing so on mine, I "brushed" away a few surface mounted devices.   amp
> still worked but meter readings were of until repaired.
>
> 73 Don
> VE6JY
>