[Icom] Icom IC775DSP

Sat, 16 Nov 2002 22:19:44 +1300

Larry - wish that was the case.  The rubber grip is removed, but there is
only a tension tightening screw under it.
I took the screw out completely in case it went into the encoder shaft - but
no such luck.

-----Original Message-----
From: [email protected] [mailto:[email protected]]On
Behalf Of Larry Winslow
Sent: Saturday, 16 November 2002 8:56 p.m.
To: [email protected]
Subject: Re: [Icom] Icom IC775DSP

I found on my 765 that there is a set screw hidden under the rubber band
around the VFO knob. It can be removed easily by prying it up with a small
screwdriver & then the set screw is accessible. I suspect the 775 might be
the same way.

73 - Larry W�NFU
[email protected]

At 08:47 PM 11/16/2002 +1300, you wrote:
>I have an Icom IC775DSP which has developed a fault in the rotary encoder,
>(the master channel tuning knob).
>
>I have removed the front panel and find the encoder is mounted on an
>enclosed bearing.  I suspect that the bearing has run dry of lubricant.
>
>To carry out further inspection, I need to remove the main tuning knob.  I
>loosened and removed the tension adjustment screw but this did not allow
the
>knob to be removed.
>
>I cannot see what is holding the knob on and therefore wonder if anyone can
>provide me with the answer.
>
>73
>Ian Watson
>ZL1IW
>
>----
>Your Moderator: Dick Flanagan W6OLD, [email protected]
>Icom Users Net: Sundays, 1700Z, 14.315 MHz
>Icom FAQ: http://www.qsl.net/icom/

----
Your Moderator: Dick Flanagan W6OLD, [email protected]
Icom Users Net: Sundays, 1700Z, 14.315 MHz
Icom FAQ: http://www.qsl.net/icom/