[Icom] Frozen Send relay - 756

Mon, 27 May 2002 19:43:27 -0400

Better yet, try a new one folks...buy the new Dual footswitch from Heil and
it has two outputs....one for your amp and the other for your rig...when you
push the footswitch...it keys the amp a split mil second before the radio.

For those of you who have the W2IHY EQ and noise gate...you can hook two
radios up to one mic or in my case the Pro Set Plus where I have choice of
the HC4 or HC5 and then a slide switch choice between my Pro II and FT1000D
and no relay question, concerns, box interfaces, or cables from the two
radio relays!!! Just a slide switch and a footswitch to make life easier for
a few bucks...The is always another way...73, Steve
----- Original Message -----
From: "Matt Erickson" <[email protected]>
To: <[email protected]>
Sent: Monday, May 27, 2002 7:27 PM
Subject: Re: [Icom] Frozen Send relay - 756

> I'm not going to try anymore. Go ahead burn-up your relays, I'm done with
> this topic!
>
> At 04:02 PM 5/27/02 -0700, you wrote:
> >At 15:42 5/27/2002, you wrote:
> >>Hi Matt. Question, are you quoting the PROll manual from page 12 which
> >>says, "Send control jack...16VDC/2A"; or the ACC(1)socket pin 3 from
page
> >>13 which says, "input current less than 200ma"? Could this be where the
> >>confusion exists. I use the send control jack and have never had a
problem
> >>with the 756, 756PRO, or PROll. Ken
> >
> >
> >My ProII manual says
> >
> >10-SEND CONTROL JACK [SEND](p.18)
> >Goes to ground while transmitting to control external equipment such as a
> >linear amplifier.
> >-Max. control level: 16 V DC/0.5A
> >
> >
> >unkadean
> >
> >
> >--
> >
> >
> >----
> >Your Moderator: Dick Flanagan W6OLD, [email protected]
> >Icom FAQ: http://www.qsl.net/icom/
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom FAQ: http://www.qsl.net/icom/
>