[Icom] IC-2100H

[Ken]

Hi Jerry. From your description it sounds temperature related, open up the
case, turn in on and apply some heat from a hair dryer, if that doesn't
work get a  can of circuit freez-it and zap each component until it comes
alive, also try pressing all over the pc board with an insulated probe,
may be a hairline crack, these tricks usually work for me, good luck, Ken 

--- jerry bishop <gbishop@deepnet.com> wrote:
> Hi All- I have a ic 2100h that seems to have a mind of it's own..
> Checked it all over and can't find anything loose or burnt.Will work
> sometimes and then quit for a few dsys. Might take a change of weather
> to very cold,then it starts up for a few days again.
> Changed the output module and that didn't do it ,then 2 days later I
> turned it back on ,and it worked again for a week.Now ,I can't get it to
> run at all.When I changed the output ,it seemed to have a little rf near
> the input to the finals.Checked with a freq. counter. Checking the
> voltage's when keying up showed almost no voltage change on the finals.
> Any ideas??? TKS, Jerry W8KQ
> 
> 
> --- StripMime Report -- processed MIME parts ---
> multipart/alternative
>   text/plain (text body -- kept)
>   text/html
> ---
> ----
> Your Moderator: Dick Flanagan W6OLD, icom-owner@mailman.qth.net
> Icom FAQ: http://www.qsl.net/icom/


__________________________________________________
Do You Yahoo!?
Try FREE Yahoo! Mail - the world's greatest free email!
http://mail.yahoo.com/