[Icom] ICOM alignment

Dave Wood [email protected]
Sun, 27 Jan 2002 15:25:49 -0500


Bob, Malcom Technical Services , see my note below for address and my last 
communication wiith them over my Icom 271/471 pair.  Dave

Date: Mon, 07 Jan 2002 17:32:46 -0800
From: SMalcom <[email protected]>
X-Mailer: Mozilla 4.77 [en] (Win98; U)
X-Accept-Language: en
To: Dave Wood <[email protected]>
Subject: Re: Trimmer Caps

Hi Dave:
The ROM card left today. I can pull the female jack from a spare PCB,
or do you need the cable end. We are talking about the bayonet gray
coax connector?
LO injections in ICOM's are generally 0 to +6Dbm, some are -15Dbm, and
then are fed directly to a +10dbm amp. In the case of the 271, +4dbm
would be the average.
Scott





At 10:07 AM 1/27/02 -0500, you wrote:
>Hi,
>
>My twenty year old ICOM 745 has lost a lot of sensitivity over the past few
>years and I figure it needs a complete tune up.  Any recommendations as to
>where the best service would be for this unit or ideas on what had decreased
>the sensitivity?
>
>Thanks
>Bob
>
>
>----
>Your Moderator: Dick Flanagan W6OLD, [email protected]
>List Archives : http://mailman.qth.net/pipermail/icom/
>List Control  : http://mailman.qth.net/mailman/listinfo/icom/

Dave Wood
1202 Essex Circle
Wilson, NC 27896

Heathkit Collector
Specializing in the clock products