[Icom] 756Pro and Behringer MX602A

Tue, 19 Feb 2002 23:16:17 -0500

I have a 602 and used it on my Kenwood 940, but haven't tried it on my Pro.
You would want to use the Aux Send of the mixer to go either into the mic
socket or the acc jack on the back.  You can use a foot switch or other type
of contact for the PTT in the acc jack (refer to the manual to which pins do
what).  If you decide to plug into the mic jack do NOT forget the decoupl.
cap.  1mfd will work great and is what Heil uses.

If you are wanting to use the mixer for the EQ then you can actually only
use 2 bands of the EQ.  The low (80hz) and the mid (2.5hz) becuause of the
digital filters of the Pro you will get practily nothing to pass above
3000hz.

Another thing you can do with a mixer is take the RX audio into the mixer
and output it to some speakers much better than the ones that come in the
radio.

The MX602 is a nice mixer for the money.  I think Mars Music sells it for
$69.  I paid $100 for mine about 1 1/2 years ago.

I hope this helped.  If not, you can emil me direct or here.
73 de Brad AE4VJ
www.ae4vj.com

----- Original Message -----
From: "Steve Garwood" <[email protected]>
To: <[email protected]>
Sent: Tuesday, February 19, 2002 9:51 PM
Subject: [Icom] 756Pro and Behringer MX602A

> Hello 756Pro users.....
>
> I'm looking for comments on the hookup of the MX602A with the 756Pro
> series....  I had heard that some use one of the rear panel connectors...
> Wondering how the PTT and cabling is addressed to make it look good....
> Thanks!
>
> Steve, N0CZV
> ===========================
> Steve Garwood, N�CZV / USAF MARS  AFA1GQ
> Attica, Ohio
> [email protected]
>
>
> ===========================
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> List Archives : http://mailman.qth.net/pipermail/icom/
> List Control  : http://mailman.qth.net/mailman/listinfo/icom/

_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com