[Icom] FSK via ACC JACK on 751A

Sat, 21 Dec 2002 15:23:11 -0500

For FSK keying of my IC-756PROII and previously, my FT-1000 MARK-V, I use
COM port Tx straight through a 1K resistor - no transistor switch.

----- Original Message -----
From: "TL" <[email protected]>
To: <[email protected]>
Sent: Saturday, December 21, 2002 1:34 PM
Subject: Re: [Icom] FSK via ACC JACK on 751A

>
> Hello again
> For those interested, I just measured it - 160 micro ampere.
> Thus - no problem to use the comm port for "almost" direct 5v generation.
> 73 Isaac, 4Z4TL
>
> ----- Original Message -----
> From: "TL" <[email protected]>
> To: "ICOM Reflector" <[email protected]>
> Sent: Saturday, December 21, 2002 7:16 PM
> Subject: [Icom] FSK via ACC JACK on 751A
>
>
> >   Hello & season's greetings
> >   How much current should one supply to pin 9 of ACC. socket when FSK is
> activated this way ?
> >   Tks, Isaac, 4Z4TL
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/
>
>