[Icom] AT-150 with other manufacturers rigs

Mon, 09 Dec 2002 23:45:46 -0800

Adam

I don't have much information on the Jupiter yet.

I did dig out my IC-745 and AT-150 manuals and take some measurements.

My plan is to build a voltage divider network in order to produce the 7
required
signalling voltages and the 8V reference.  I will then run these through a 7
position
single pole rotary switch and 7-pin DIN connector so that I can put the
AT-150 on the right band manually.   I believe the AT-500 already has this
feature,
but the AT-150 does not.

That will be my first cut at this project.  Once I have more information
on the Jupiter, I will try to devise something to do the bandswitching
automagically.

73 de Gary
VE7GGJ

Adam Farson wrote:

> Gary,
>
> You will need to come up with a scheme to translate whatever band-related
> data comes out of the Jupiter into the 0 ~ 8V DC band-selection voltage
> required by the AT-150.  Icom has grouped 17m with 15m, and 12m with 10m.
>
> Best 73,
> Adam, VA7OJ/AB4OJ
> North Vancouver, BC, Canada
> http://www.qsl.net/ab4oj/
> Icom FAQ site:
> http://www.qsl.net/icom/
>
> -----Original Message-----
> From: [email protected] [mailto:[email protected]]On
> Behalf Of Gary Jacek
> Sent: Sunday, December 08, 2002 10:40
> To: [email protected]
> Subject: [Icom] AT-150 with other manufacturers rigs
>
> I have an Icom AT-150 that I would like to use with a Ten Tec Jupiter HF
> transceiver.
> Is this possible?
> What do I need to build in order to trigger tuning and antenna switching in
> the AT-150?
>
> Gary
> VE7GGJ
> [email protected]
>
> ----
> Your Moderator: Dick Flanagan W6OLD, [email protected]
> Icom Users Net: Sundays, 1700Z, 14.315 MHz
> Icom FAQ: http://www.qsl.net/icom/