[HoustonHam] Looking for

[Charles.Frost at aliefisd.net]

True 

 

________________________________

From: houstonham-bounces at mailman.qth.net [mailto:houstonham-bounces at mailman.qth.net] On Behalf Of Chris Boone
Sent: Friday, October 31, 2008 9:36 AM
To: 'Amateur Radio in Houston TX area'
Subject: RE: [HoustonHam] Looking for

 

As long as its all copper braid,  the foil+copper shield is no good in repeater service!

 

From: houstonham-bounces at mailman.qth.net [mailto:houstonham-bounces at mailman.qth.net] On Behalf Of Charles.Frost at aliefisd.net
Sent: Friday, October 31, 2008 9:21 AM
To: houstonham at mailman.qth.net
Subject: RE: [HoustonHam] Looking for

 

They have also some RG6/U that we have used for the 40 meter 4 sq. leads. It is copper braid coax. 

The velocity factor might not be right.

 

Frosty

 

________________________________

From: houstonham-bounces at mailman.qth.net [mailto:houstonham-bounces at mailman.qth.net] On Behalf Of Chris Boone
Sent: Friday, October 31, 2008 9:18 AM
To: 'Amateur Radio in Houston TX area'
Subject: RE: [HoustonHam] Looking for

 

Tnx Frosty!! Wasn't sure if EPO  did or not... need to make up some new harnesses for some DB and other antennas!!

Chris

WB5ITT

 

From: houstonham-bounces at mailman.qth.net [mailto:houstonham-bounces at mailman.qth.net] On Behalf Of Charles.Frost at aliefisd.net
Sent: Friday, October 31, 2008 7:08 AM
To: houstonham at mailman.qth.net
Subject: RE: [HoustonHam] Looking for

 

Chris,

EPO has some and Les will cut what you need.

 

Frosty

K5lbu

 

________________________________

From: houstonham-bounces at mailman.qth.net [mailto:houstonham-bounces at mailman.qth.net] On Behalf Of Chris Boone
Sent: Thursday, October 30, 2008 7:34 PM
To: SETXHam at yahoogroups.com; Houstonham at yahoogroups.com; 'Amateur Radio in Houston TX area'
Subject: [HoustonHam] Looking for

 

In need of some RG-11 (yes 75ohm) coax...preferably non foam but solid dielectric. Don't need much but the local sources only have it on reels and don't want to cut it by the foot.

 

Also anyone know where I can find 2 ¼" wide stainless steel U Bolts....the local ACE hardware had 2 and 2.5 but no 2.25 (figures!)...

 

Thanks!
Chris

WB5ITT

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/houstonham/attachments/20081031/7edea582/attachment-0001.htm