[HomeBrew] TOROID WINDING TOOL

[R Blackman]

Hello to all on list. Stay well.

trying lately to wind a T37  with my fat sausage fumble fingers was just too frustrating.
So I set out to create a small toroid holder for T37 and T50’s
It holds the toroid for easy winding, and better yet, it you tape it to your bench,
or hold it lightly in a vise, you have two hands free.

If you have access to a 3D printer, the .stl files are here:

https://drive.google.com/drive/folders/1-kZKi-q8IY4GcwznRpzaPB9sKejivpQv?usp=sharing

if you do not have access to a printer, at least there is a photo of the tool for your info.

The two halves snap together to hold the toroid.  
The first time you snap them together may be tight, but they do in fact fit.

CAUTION:  this was designed for proper AMIDON toroids, not the cheap Asian mystery clones on auction sites
that are always slightly “off size”  YMMV.

Enjoy  
Richard / VA3NDO

-- 
This email has been checked for viruses by AVG.
https://www.avg.com