Fw: [HomeBrew] parts needed

Fri, 2 Apr 2004 20:50:43 -0000

Go to a welding supply house or a crafts store and git some 1/4" or what
ever size need welding rod then cut to length kc8eaf
----- Original Message ----- 
From: "Edward B Richards" <[email protected]>
To: <[email protected]>
Sent: Friday, April 02, 2004 7:39 PM
Subject: [HomeBrew] parts needed


> Hi Guys;
>
> I am modifying a 3" scope to be used as an AM modulation monitor by
> adding a DPDT switch to the vertical plates to switch between "normal"
> use and "mod mon". This rotary switch will mount at the back near the CRT
> socket with a long shaft through the front panel. The switch does not
> line up with the hole in the front panel, so I need a flexible coupling
> for a 1/4 inch shaft. On the other side I will mount a variable capacitor
> as a vertical size control with another long shaft that does not line up
> either. Another flex coupler. I also need the capacitor. The needed parts
> are:
>
> 2 each flexible 1/4" shaft couplings
> 1 each panel mount variable capacitor (small) about 20-25 mmfd ( pfd ).
>
> Can anyone help me? Thanks.
>
> 73, Ed Richards K6UUZ
>
> _______________________________________________
> HomeBrew mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/homebrew