[Heathkit] Parts for Heath 2060 and 206A tuners

[tchesek]

The switch wafer is a tough one. I had to replace a broken one in a 2060-A quite a while ago. It took a lot of searching until I found a Russian made switch on eBay that had combinations that provided proper switching. Good luck.

Tom K3TVC


----- Original Message -----
From: manualman at juno.com
To: heathkit at mailman.qth.net
Sent: Fri, 09 Nov 2018 16:16:30 -0500 (EST)
Subject: Re: [Heathkit] Parts for Heath 2060 and 206A tuners

Depending on what was damaged in the sensor, it might be easier to just
replace the damaged parts. It's mainly 2 diodes (1N295 or equivalent),
and some resistors and capacitors.

Pete, wa2cwa

On Fri, 9 Nov 2018 20:39:41 +0000 (UTC) John King via Heathkit
<heathkit at mailman.qth.net> writes:
> I have two tuners, Heath 2060 and Heath 2060A, that got a DOSE of 
> lightning and only one of the baluns was damaged but both  of the 
> SENSORS got a charge and were damaged. I have a replacement balun, 
> but need parts for the sensors including the switch wafer.
> If anyone has used sensors (possibly in the metal boxes, I need 
> pieces parts. I may have to homebrew a couple of sensors, but prefer 
> to acquire new or USED sensors to replace mine.
> If anyone has a sensor for the Heath 2060 or 2060A lying around that 
> you will dispose of, please let me know. I will be very 
> appreciative.
> Also, based upon your actual knowledge AND experience, I would 
> appreciate your suggestions.
> Thanks and 73, John, K5PGW

______________________________________________________________
Heathkit mailing list
Home: http://mailman.qth.net/mailman/listinfo/heathkit
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Heathkit at mailman.qth.net

List Administrator: Gary Harmon, K5JWK
** For Assistance: gharmon at idworld.net **


This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html