[Heathkit] Heath Items FS

[Ken, W8EK]

Heath Items For Sale:
.

.
Meter for Heath SB-220 HF Amplifier:

The Heath SB-220 HF Linear Amplifier uses two meters.
One measures plate current, and the other measures
whatever is selected by the meter switch, which includes
grid current, high voltage, or relative power output.
Both of these meters are electrically the same, but have
a different scale on them, which can be changed.  In
other words, one meter can serve either purpose.

I have very nice multi meter available.  It works fine,
and looks extremely nice.  This one has the multi scale
on it, but could be changed to plate current by using
the scale from your dead meter.

This is original Heath, complete with the hole for the
pilot bulb.  These meters are quite scarce these days.

Buy this one for $80.
.

.
Matched pair of 572 B tubes

572 B tubes are used in the Heath SB-200 HF Amplifier.
This is a set of Taylor "Premium Grade Matched Tubes" from
RF Parts.  They are new, in their original boxes.  Since
these came from a silent key, I did remove them from the box
and test them in a SB-200 for a couple minutes.
Other than that they are unused.  $125 for the pair.
.

.
Heath Power Supply Cable:

This six foot long 8 conductor cable has a female
11 pin "octal" connector on one end, and a 15 pin
rectangular Jones plug on the other. My memory
says that this cable is used with the Heath HP-13
DC supply which is used to power the SB-100/101/102,
HW-100/101, and the HW single banders for mobile use.

This one looks fine. Only $20.
.

.
Resistors for high voltage metering:

Do you have a linear amplifier that has an
error in the high voltage reading? Maybe you do
not even know it has an error!

Heath used three 4.7 meg resistors in the SB-220/221
and also in the SB-200/201 amplifiers. Almost all
of these resistors are out of tolerance today, partially
because of their age, but also because their voltage
rating was exceeded.

I was able to obtain a quantity of new resistors that
are 4.7 Meg, 1% tolerance, 2 watt, and are rated to
handle the high voltage. This compares to the original
resistors furnished by Heath that were 4.7 Meg, 5%,
1 watt and about 400 volts.

Note that these can be used in any amp that uses the
4.7 Meg resistors -- not just Heath amps.

Buy a set of three for $3 plus shipping from Florida.
Combine with other items to save shipping!
.

.
SB-221 Front Panel
Standard green color. In very nice condition. $50
.

Heath SB-630 Station Console parts available.
Most internal parts are available, with the exception
of the clock. The outer case is gone.
.

Parts from a Heath HD-15 phone patch available,
including the cover which fits other Heath products.

What do you need?
.

.
ORIGINAL Heath manuals:

These are original manuals only, for Heath equipment.
They are in very nice condition. Schematic is in the book.

GD-600 Photoelectric Light Switch, $4
HA-10 Warrior HF Amplifier, $12
HD-1234 Coaxial Switch, $3
HD-1481 Remote Coax Switch, $7
HD-4040 Terminal Node Controller, $8
HD-4040-2 TNC HF Header Kit, $2
HM-2102 VHF Wattmeter, $6
HN-31 Cantenna RF Dummy Load, $5
HW-2021, 2 meter HT, No check marks, $9
HW-2036, 2 meter transceiver, partial manual, $8
IN-17 Decade Resistance Box, $4
SB-1000 HF Linear Amplifier, $22

These are original Heath manuals only.
.

.
I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.
.

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400




.



.