[Heathkit] Plug for Heathkit VF1 VFO

[Glen Zook via Heathkit]

Those plugs are no where near as plentiful as they were when most home television installations used 300-ohm twin lead.  You can use the holder from an FT-241 or FT-242 crystal that has gone bad.  Remove the quartz and then drill a hole in the top of the holder through which RG58/U can pass.  Solder the shield to one pin and the center conductor to the other pin. Glen, K9STH

Website: http://k9sth.net
      From: Bert Morton <w1dfu at vermontel.net>
 To: Heathkit at mailman.qth.net 
 Sent: Tuesday, February 3, 2015 4:10 PM
 Subject: [Heathkit] Plug for Heathkit VF1 VFO
   
I am looking for the plug that was used to connect the VF1 to the 
crystal socket of the AT1 as well as other rigs.

If I remember correctly it could also be used in an arrangement to 
connect to pieces of 300 ohm twin lead together