[Heathkit] Need IO-104 Oscilloscope Vertical Attenuator Switch

[Donald Spoon]

I have a Heathkit IO-104 O'scope that appears to be in working order 
except for a broken rear wafer on the Vertical Attenuator Switch 
(SW2-5F).   Does anyone have a "junker" IO-104 that this switch could be 
liberated from?   I can probably get by with replacing just the rear 
wafer, but it looks like just replacing the entire switch would be about 
the same amount of work IF I didn't have to re-wire the whole thing.   
There are only a handful of connections to the vertical board, that 
don't appear to be too much of an obstacle to removing the switch 
"en-block".

In lieu of the above, I am considering building my own from an old 
12-position single pole wafer that fits.  Anybody done this before??  

Another option is careful removal of the wafer and attempting repair by 
judicious use of super glue to get the broken parts back together.   I 
don't hold much hope for this, but it is worth a shot as a last resort.

If I can't do any of these, then I have the "junker"!  As I said, the 
other parts seem to be OK including the CRT.

Thanks In Advance!

-Don Spoon-
K0APK