[Heathkit] HL 2200 Amp

[jeremy-ca]

Why?? Do you have a manual/schematic? If not then get one.  The switch 
selects transformer taps.

When that amp was built the FCC regulations were 1000W DC input on CW and 
2000W PEP on SSB.

Carl
KM1H


----- Original Message ----- 
From: "Jerry Judy" <ke8npjmj at ameritech.net>
To: <heathkit at mailman.qth.net>
Sent: Saturday, November 24, 2007 11:56 AM
Subject: [Heathkit] HL 2200 Amp


>  I have a question about the high voltage.   In the cw position on the 
> high voltage I have 2400 volts.  In the SSB position I have 3200 volts. 
> Why?  I could swear the both were
> 3200. Is this normal reading for each aswitch position???KE8NP
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF        ** For Assistance: 
> dfischer at usol.com **         $$ See the vintage area on the HCI web site - 
> http://www.w9wze.org $$ Heathkit mailing list
> Heathkit at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/heathkit
>