[Heathkit] Source for 125 uf 450V electrolytics?

[crawfish]

I have some pins for the 1625-type sockets. While we are on the subject of
DX-100 electrolytics, does anyone have any modern sources and part number
for those caps? I need to replace all the electrolytics in my DX-100B.
                                                        Joe W4AAB

Sent: Friday, February 02, 2007 6:01 PM
Subject: [Heathkit] Source for 125 uf 450V electrolytics?


> I was looking at the circuit of my DX-100 today which I haven't powered up
> yet and found a couple of problems, one, someone unhooked the two 125 uf
> cans and soldiered some Axial 100 uf 450 V electrolytics underneath in
their
> place.
> I was also lucky to notice that one of the sockets for one of the 1625's
> filiment clips had lost it's rivet and was just touching the bottom of the
> pin. I had taken this tube out before so I'm not sure if I did it or if it
> was already like that, the clip will and did snap on but I did find a
source
> for that: Antique Radio Supplies has one specifically for the 1625, was
one
> of the filiment pins.
>
> Bob Young
> Millbury, Ma KB1OKL
>
>
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
> $$ See the vintage area on the HCI web site - http://www.w9wze.org $$
> Heathkit mailing list
> Heathkit at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/heathkit
>