[Heathkit] SB-102 question
Edward B Richards
[email protected]
Tue, 20 Apr 2004 08:57:34 -0700
Hi Ken;
The manual calls for soldering the pulleys to the shaft. Apparently the
builder didn't solder it properly. It is quite a heat sink so it will
take a lot of heat. Good luck.
73, Ed Richards K6UUZ
On Mon, 19 Apr 2004 17:12:14 -0700 "Ken Kaplan" <[email protected]>
writes:
> I have a nice SB-102 that has loose pulleys on the Driver/Preselector
> shaft. They are
> so loose that the shaft turns but they don't. A previous owner tried
> to anchor them
> with solder but it came loose. How were they originally installed?
> It looks like they
> were a compression fit. Were they already on the shaft or did the
> builder have to
> slide them into place? I guess I could break out the JB Weld but
> then I would
> become a DPO (Dreaded Previous Owner). Any suggestions/thoughts?
>
> Thanks,
> 73 Ken kb7rgg
>
> _______________________________________________
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: [email protected] **
> $$ See the vintage area on the HCI web site - http://www.w9wze.org
> $$
> Heathkit mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/heathkit
>