[Heathkit] SB-104 extenders question

Thu, 18 Dec 2003 16:57:14 +0000

   It is really quite simple!

   You cut several pieces of hookup wire about 6 inches long
(or as required) and strip 1/8" of the insulation from both ends.
   Tack solder one end to each test point (on the underside of the board)
that are needed and return the module into it's slot. (label as required)
   When all are completed and no exposed ends are touching anything,
power up the equipment and move the volt meter or 'scope probe around as required.
   When done, power down and remove all test wires.

   Ron

> I have almost finished the electrical restoration of my SB-104 and am ready to
> do a front end alignment, but as must be all too common, I do not have an
> extender board.  I am interested in hearing what others have done in this
> situation.  Can you make a board? If so where can you get th parts, can you get
> away clip leads.
-- 
        73 (= Best Regards) de: Ron [email protected]
     100% LINUX, since July, 1997   SENT Time and Date are UTC
        Visit my HAM Web SITE at: http://www.qsl.net/ka4inm