[Hammarlund] SP-600-JX14

[Richard Knoppow]

    I actually have this tool but never tried it. Thanks for the 
heads up.

On 8/22/2020 11:54 AM, Al Parker wrote:
> Hi folks,
>     A small, curved, hemostat works just fine to remove and 
> install the clips.  I've probably done over 100 that way in the 
> last 20 yrs.  I've got several, strait and curved, come in very 
> handy.
> 73,
> Al, W8UT
>
> On 8/22/2020 11:16 AM, Joe Connor via Hammarlund wrote:
>>   The are BB caps on the turret modules. Hammarlund had a
>> special wrench for getting them out. Its a PITA to do without the
>> tool but can be done.
>> The modules are held in by spring clips. If you're not very, 
>> very careful, those clips can go shooting off and travel 
>> remarkable distances. They also have a habit of landing in the 
>> damnedest places. I think the BBs are only in the modules for 
>> the lower two bands.
>>                                    Joe Connor
> ______________________________________________________________
> Hammarlund mailing list
> Home: http://mailman.qth.net/mailman/listinfo/hammarlund
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Hammarlund at mailman.qth.net
>
> List Administrator: Gary Harmon, K5JWK
> ** For Assistance: gharmon at idworld.net **
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html

-- 
Richard Knoppow
1oldlens1 at ix.netcom.com
WB6KBL