[Hammarlund] SP 600-JX-17 and CE SSB slicer

[Richard Knoppow]

----- Original Message ----- 
From: "Jimmy Green" <honobia061960 at hughes.net>
To: <hammarlund at mailman.qth.net>
Sent: Monday, February 18, 2013 8:26 PM
Subject: [Hammarlund] SP 600-JX-17 and CE SSB slicer


>I have a Central Electronics B slicer w/ Q multiplier.  I 
>would like to connect to a Sp 600-JX-17.  There are 4 RCA 
>and one 5 pin plugs on the back of the slicer.One RCA 
>labeled IF in, one Vol. Cont., one Rec. det.,and one AF 
>out.
> The 5 pin I have know idea where are what it connects to.
> Will someone tell me how to connect these units, I do not 
> wish to cause smoke to rise.
> Thank you in advance,
> Jimmy K5CSU

IF in connects to the IF output jack on the receiver, its 
marked and is on the back apron of the chassis.
Rec. Det means receiver detector.  I am not sure why it 
needs this but you can use the detector output on the SP-600 
Volume control, I am not sure about this one, it may be 
either a way to feed to audio input of the receiver or for a 
remote volume control.  AF out is audio out, which could be 
either low level to go back to the receiver or high level to 
drive a loudspeaker. Have you looked at BAMA for an 
instruction book?
    I am still preparing some alignment hints for the JX-17. 
Please be patient.


--
Richard Knoppow
Los Angeles
WB6KBL
dickburk at ix.netcom.com