[Hammarlund] switches for SP-600

[James A. (Andy) Moorer]

I had no problem fitting them behind the panel. There is one minor problem: 
In the original Hammarlund switches, the solder lugs point UP, whereas the 
Carling switches have the solder lungs pointing DOWN. This is o.k. 
everywhere except the receive/standby switch - that switches the B+ so it is 
HOT. If you lift up or adjust the receiver with the power on, you will get 
knocked across the room. I ended up putting a couple of layers of shrink 
tubing on them and bending the solder lugs 90 degrees left and right .

James A. (Andy) Moorer
www.jamminpower.com

----- Original Message ----- 
>
> I think the Carling p/n given is a .250" blade or tab terminal type. 
> Wondering if this will fit behind the panel.