[Hammarlund] What do you think? SP-600 transmitter

[Tom NØJMY - AAR7FV]

Need to do that anyway, as the lettering on the SP-600 is recessed.

73,
Tom
----- Original Message ----- 
From: "Todd, KA1KAQ" <ka1kaq at gmail.com>
To: "GBrown" <gkbrown at gwi.net>
Cc: <hammarlund at mailman.qth.net>
Sent: Monday, June 20, 2005 10:25 AM
Subject: Re: [Hammarlund] What do you think? SP-600 transmitter


Gary -

If you got a decent panel you could probably flip it and use the
reverse side for lettering? This assumes you could use the current
holes for existing controls. Would make it easier to deal with and
also give you a reuseable front panel in a pinch, if you needed it.

~ Todd,  KA1KAQ

On 6/18/05, GBrown <gkbrown at gwi.net> wrote:
>
>
>
> > WANTED:
> > SP-600 front panel. Does not have to be good. Don't even care if 
> > there's
> > extra holes. Would like the two dial trim pieces as well. Your all
> wondering
> > why.........well, I have never seen this done before so I am going 
> > to try
> > and do a "first".
> > After doing the restoration on a SP-600/JX-1, I have decided to 
> > build an
> AM
> > transmitter, using the front panel of an SP-600, but...........only 
> > in
> > reverse. I think this would be unique to see these sitting side by 
> > side in
> > the ham shack. VFO/XTAL controlled, 100 watts, AM and CW.
> > What's your thoughts?
> > Regards,
> > Gary...WZ1M
> >
>
> _______________________________________________
> List Administrator: Duane Fischer W8DBF
> ** For Assistance: dfischer at usol.com **
> ----
> http://mailman.qth.net/mailman/listinfo/hammarlund
>
_______________________________________________
List Administrator: Duane Fischer W8DBF
** For Assistance: dfischer at usol.com **
----
http://mailman.qth.net/mailman/listinfo/hammarlund