[Hammarlund] SP-600 Xmtr project

[James A. (Andy) Moorer]

I had some brand-new ones made up last year. Unfortunately, since it was a 
small lot, I have to sell them for $140 each, and at that, I am not really 
making any money. I can post some pix upon request. They are accurate to the 
last detail, including the detent holes in the back. There are a couple of 
details the shop copied that I wish they hadn't - they drilled holes for the 
Navy ID plate, and most folks like to put an Army Signal Corps ID plate on 
them (I gave them a Navy original but neglected to tell them about the ID 
plate holes, so they just copied it exactly - except minus the corrosion). 
Unlike the original, however, they are primed on the back as well, so they 
should hold up as well or better than the originals.

I don't have any used ones to sell.

James A. (Andy) Moorer
www.jamminpower.com


----- Original Message ----- 

>I have collected many parts for my "HB-600", matching SP-600 project. "HB"
> is Home Brew. I am using a pair of 813's modulated with a pair of 811's.
> What I really need is the front panel to an SP-600. Condition doesn't
> matter. Would also like the window trim pieces and even the knobs. Front
> panel is my main want at this time. Any out there?????????
> Regards,
> Gary...WZ1M
>